Gyroscope
From Maslab 2011
(Difference between revisions)
Yichen (Talk | contribs)
(Created page with "See the Orc Manual, section 4.3. You can either make a cable as shown there, or (carefully!) solder one piece of female header to a position in the fourth row of the I/O pins on...")
Newer edit →
(Created page with "See the Orc Manual, section 4.3. You can either make a cable as shown there, or (carefully!) solder one piece of female header to a position in the fourth row of the I/O pins on...")
Newer edit →
Revision as of 22:05, 24 December 2010
See the Orc Manual, section 4.3. You can either make a cable as shown there, or (carefully!) solder one piece of female header to a position in the fourth row of the I/O pins on the orcboard, so that you can plug it in directly. The fourth row is also signal, and is connected directly to the third row.
